Hi, i have a DL360 G6 currently at home to upgrade it. Ram Upgrade fine / First CPU Upgrade fine. CPU is detected and works normal. But if i put the second cpu in the system, it wont boot. The fans start slowly and ramp up, then down again. This is an infinit loop.
I tried:
- Running with minimal (1 DIMM per CPU / 2 DIMMS per CPU)
- Resseting NVRAM and BIOS
- Updating ROM to newest version, also to older version
- I looked for bent pins on the second cpu socket, but if i only put a cpu in there, it boots until ilo2 config, and then it halts because "Cpu is in wrong socket"....
- Checked and Swapped Fans, isnt a problem.
- Plugging both power supplies in
- Ilo2 Doesnt show anything. It says no information available...
- The CPUs are the same, and i dont know why 1 would run, but the second doesnt. Is there anything else i can try?
PLEASE HELP ME.... i am working 13 hours on this and havent found a solution or a answer. Thanks in advance!