I have just recently installed a P410 Raid Controller in a HP Proliant DL 160 G6 so that I can run it with ESXi. As I found out the hard way a physical RAID controller is required in order to run ESXi. I have hot-plug SATA drives and to my knowledge I have installed the card correctly. Pictures attached.
However, when I boot up the server it is not seeing the P410 controller. And I can see that it still tries to go the Smart Array B110i controller (which of course does not work). What do I need to do to make the server use the P410?
I have searched the ROM System Setup Utility and I cannot see anything that does this.
Any help would be greatly appreciated. Thank you.