During POST I get the message
"Warning - iLO3 not responding. System health monitoring has been disabled"
Then later
"iLO configuration is temporary unavailable"
I have attempted the following;
Soft reboot.
Turning Security Ovverride switch to on:
This causes the system to hang during POST after the message "Inlet Ambient Temperature", keyboard is unresponsive and a flashing cursor.
I then proceeded to fully power off the system and remove the power cables and left it for at least 5 minutes. When I powered it back on, I get similar messages.
With the Security Override switch set to on, and switch number 3 set to on. The system is able to complete post but I still get the messages of iLO3 unresponsive and temporary unavailable. I booted from a USB with Smart Firmware Updater, and typed "Ctrl+Alt+d+b+x", then in the command prompt I navigated to hp/swpackages, and I ran
rmmod hpilo
./CP020301.scexe --direct
It looks like it was successful in the flashing attempt.
It placed the iLO into reset mode, then began erasing, and then flashing began and then it was done.
After that I still wasn't able to get iLO to work again, even after switching the switches back to off again.
It was running either v1.50 or v1.55
Is there anything else I can try to attempt to revive iLO3? or at this point do we call it dead and have the motherboard replaced?