how to set bootable volume on e200i ?

Hi

I have e200i controller

And i have two logical drives

raid0 with 1 driver

and raid1 with two drives

raid0 was active and bootable, but not redudant. I install the system on the radi1, and made a clean drive on raid0.

So if raid0 EXISTS as an array system won't boot. System boots only if i delete raid0 array. How can i change boot sequence ?

On p400i there is an option "set bootable/logical drive volume" at offline HP Smart Storage Administrator. But i don't see such option. What to do ?

Thanks

P.S. This thread has been moved from Storage > General to ProLiant Servers (ML,DL,SL). - Hp Forum Moderator