Hello!
I have HP ProLiant DL380 G5 server with SmartArray P400i. After brief absence of electricity, Array left off to see a disk.
At the start of server a next error isvisible:
1787-Slot 0 Drive Array Operating in Interim Recovery Mode. The fallowing disk drive(s) are mismatched types and should be replacet.
In a Array Configuration manager evidently following:
1. 274 1 TB SATA Drive at Port 1I : Box 1 : Bay 2 is bad or missing. To correct this problem, check the data and power connections to the physical drive.
2. Logical drive state: The current array controller has a bad or missing drive. This logical drive is operating in interim recovery mode with reduced performance and a further physical drive failure may result in data loss depending on the fault tolerance.
To clean an error last firmware set. Did not help. Into place of bad disk tried to put other disks. An error did not change.
What can be done, to correct mistake?
P.S. This thread has been moved from Disk Array to ProLiant Servers (ML,DL,SL). - Hp Forum Moderator