This drive was previously installed on another server and operated fine on that server for the past two years. I installed it to a new HP ML370g4 and it recognized without any issues. But after having issues with it aborting backup jobs (using Veritas BackupExec) I tried to update drivers. It stopped recognizing in BackupExec at which point I reinstalled HP drivers. Then it didn't show in Windows at ALL anymore. Suddenly during one of the reboots it reappeared. However, it still wasn't working in BackupExec. Then I tried to update the firmware (as recommended by Veritas) - to do this required installing the HP Tape Utility software. After I did that the drive stopped appearing in Windows again - I haven't been able to get it back since. I noticed this error in the Event Log:
SCSI Tape Drive Status Change.
The tape drive with SCSI target 5 connected to SCSI bus 1 of the controller in slot 0 has a new status of 5.
(Tape drive status values: 1=other, 2=ok, 3=failed, 5=offline, 6=missingWasOk, 7=missingWasFailed, 8=missingWasOffline)
[SNMP TRAP: 5019 in CPQSCSI.MIB]
The tape drive previously recognized in BackupExec as Port 2, Bus 0, Target ID 5, Lun 0.
Any ideas?
P.S. This thread has been moevd from General to ProLiant Servers (ML,DL,SL). - Hp Forum Moderator