I've just purchased a used SE316M1, which I think is basically a close cousin of the DL160. Upon starting it up, it complains that the "System Maintenance switch is in the ON position", and to power off the server and turn it to the OFF position. From the manual, I can see the 'switch' is actually a bank of jumpers (J27 to be precise) and I've tried these in the OFF position but it's still in maintenance mode. However, the location of J27 in the manual is not the same location as on the motherboard.
In the manual (http://h20628.www2.hp.com/km-ext/kmcsdirect/emr_na-c01728029-10.pdf), pages 109-110 describe the location of J27 and the settings for the bank of 5 jumpers. However, J27 on my motherboard is not in the place the manual says it is - mine is as shown here (http://i.imgur.com/6y9L8LC.jpg).
So:
- there's a discrepancy in the manual perhaps?
- no matter if I set the jumpers as per picture, or I remove all 5, I still get the "System Maintenance switch is ON" message.
Does anyone have any ideas?
Many thanks,
Steve