Remote console, SSL certificates, and port 80

Hi All

Hopefully there’s somebody out there than can help with this issue.

I have a StoreEasy 1450 with ILO4 out on a customer site. The customer has configured a port forward from 4433 to 443 so I can get access to the ILO interface.

I can log in to ILO but when I try and launch the remote console nothing happens.

After a bit of Googling I believe it may be trying to redirect through port 80 due to an untrusted certificate.

http://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=5195931&docId=mmr_kc-0106591&lang=en-us&cc=us&docLocale=en_US

However the above article states that Java RC would work, but for me it does not.

The site is added to trusted sites in IE, and I have tried with protected mode off.

IE, Chrome and Firefox all the same, nothing happens and no clue why.

So I have installed a Digicert certificate which is trusted by the browser, but maybe not by the web server in ILO, not 100% sure about that.

Still no joy.

Ports 443 and 80 are in use so there is no option to use them.

I’m pretty sure it’s not a client side issue.

ILO Firmware is 2.10

The digicert SSL certificate was sent with a certificate for an intermediate trusted CA, but it looks like only one SSL certificate can be installed in ILO.

I believe this must be a very common usage scenario given most small businesses only have one public IP address, and would be hosting a website on port 80

Any succinct thoughts and suggestions gratefully received.