Hi!
I'm a new owner of a HP ML10 v2 (G3240).
I set in the bios the sata controller on this "ENABLE SATA AHCI SUPPORT".
I also installed 3 HDD:
port 1: 1Tb HDD (the one sold with the server, empty)
port 2: 1,5Tb HDD (not empty)
port 5: 30Gb SSD (this is placed in a ODD bay and connected to the first SATA port free in the motherboard).
Today I have installed ESXi 6 (with the HP custom image) in the SSD drive: all was fine, but the system can not boot from the SSD. If I disconnect the 2 HDD on port 1 and 2, ESXi can boot normally.
It seems to me that the system test if the first HDD drive is bootable and, if not, it goes forward.
How can I set the system to boot from SSD?
Thanks for attention.
