Hi,
Initially, I had only one HDD with RAID 0 in HP DL380 Gen8
Then I added secondary HDD and tried to setup RAID 1+0 so that secondary HDD can be used as a backup of primary
From ACU, I did not see any option to setup 1+0 but it was showing me option to expand the RAID volume with additional disks so I did it and I was able to select RAID 1 setting on Secondary HDD ( which was not the case initially ) and after the process completion, it showed:
Logical drive 1: Capacity 931 GB
Fault Tolerance: RAID 0
Physical drive| Box2 Bay1
Capacity 931 GB
Physical drive| Box2 Bay2
Capacity 931 GB
Logical drive 2: Capacity 465 GB (Status: Degraded, Ready for rebuild)
Fault Tolerance: RAID 1/RAID 1+0
Physical drive| Box2 Bay1
Capacity 931 GB
Physical drive| Box2 Bay2
Capacity 931 GB
Also, when I tried to test the RAID setup and tried to boot from just secondary HDD, I was not able to boot from it
Did I make any mistake in RAID set up? Is there any solution for it?
Can HP experts please help me on this?
Thanks!
Harshal Patel