HP ProLiant ML10 v2 Server SN: CN65250CR1
Hello everybody,
I am using the two NICs on the HP ML10v2 in IEEE 802.3ad Dynamic link aggregation with a Cisco SG300-28 switch, however the iLO shared NIC stops working in this mode and I don't know how to fix this under Debian 8 or Redhad 7 and would like some help.
http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c04822945&sp4ts.oid=4154735
Kind regards,
Jelle de Jong
GNU/Linux Consultant.
# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
Bonding Mode: IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2+3 (2)
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 400
Down Delay (ms): 400
802.3ad info
LACP rate: slow
Min links: 0
Aggregator selection policy (ad_select): stable
Active Aggregator Info:
Aggregator ID: 1
Number of ports: 2
Actor Key: 17
Partner Key: 28
Partner Mac Address: 00:25:84:ce:df:e6
Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 30:8d:99:cc:1e:30
Aggregator ID: 1
Slave queue ID: 0
Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 30:8d:99:cc:1e:31
Aggregator ID: 1
Slave queue ID: 0