1.I wonder what's the sensor HD-Max. I guess it's the max temperature of the HDDs
2.My ML350p Gen8 shows HD-Max "not installed". I have two HDDs installed on the device, a Seagate 500GB and a Seagate 2TB, both are desktop HDDs I previously bought for my desktop PC. The controller is at AHCI mode, with each disk configured as a separated array. The HDD trays are ones without LEDs from my previous MicroServer Gen8. iLO shows storage degraded. I used my own HDDs torn out from my portable HDD for my previous DL360p Gen8 with LED trays, it didn't show degraded at the default settings.
3.I have the server by my bed, unfortunately. I had a peaceful time with it with all its fans at 6%, it was pretty quiet by then.
Windows Server 2012 R2
1*E5-2670
4*4 ECC 1333MHz
Array controller at IDE mode
But it has been noisy recently, I reconfigured the array controller as AHCI mode, with two of the three fans going up to more than 10% (I see 19% once). They go up only for a short moment and goes back to 6%, but this happen once a few seconds, really annoying. So is there a solution? If possible I hope I can keep AHCI mode.
2.My ML350p Gen8 shows HD-Max "not installed". I have two HDDs installed on the device, a Seagate 500GB and a Seagate 2TB, both are desktop HDDs I previously bought for my desktop PC. The controller is at AHCI mode, with each disk configured as a separated array. The HDD trays are ones without LEDs from my previous MicroServer Gen8. iLO shows storage degraded. I used my own HDDs torn out from my portable HDD for my previous DL360p Gen8 with LED trays, it didn't show degraded at the default settings.
3.I have the server by my bed, unfortunately. I had a peaceful time with it with all its fans at 6%, it was pretty quiet by then.
Windows Server 2012 R2
1*E5-2670
4*4 ECC 1333MHz
Array controller at IDE mode
But it has been noisy recently, I reconfigured the array controller as AHCI mode, with two of the three fans going up to more than 10% (I see 19% once). They go up only for a short moment and goes back to 6%, but this happen once a few seconds, really annoying. So is there a solution? If possible I hope I can keep AHCI mode.