Hello all
I bought a DL380 G4 recently so I could install VMWare on it (G3 doesn't support it, I found out to my dismay).
It was diskless, but I had the six Ultra320 disks in my G3, so figured I could swap them into the G4.
2 x 146GB
4 x 300GB
Previously when doing things like this, I've booted into SmartStart and deleted all array config, and created the arrays I need. Only this time, the G4 is only seeing the two 146GB disks....none of the 300GB ones?
I know the disks are ok because they've come out of the G3, and were working fine, and have had no impacts or issues in the five minutes they were physically swapped over. So I'm guessing I need to do somethign I've never had to do before...(?) to get them to work.
In SmartStart (I'm using v8.15 I think) there's an option to Erase everything, including disks and arrays etc. I've been through this and still the four 300GB disks aren't showing.....no chance to create an array with them...
Any help much appreciated,
Many thanks,
Will