Hello Everyone,
My server (DL380 G5) is unable to display and pass POST : no VGA display and fan spinning at maximum.
I've read a lot of threads on this forum and the troubleshooting guides, tried to boot with minimal RAM and no disk, ...without success.
About the port 84/85/iLo, it starts displaying things on iLo boot (after plugging the power cable). It then stays with led 7 and 8 bliking at different frequencies.
But when I start the server, these two leds shut down and stay black. Does it means it cannot find the error?
Also, in the Troubleshooting Guide, there is this sentence :
IMPORTANT: Be sure the port 84/85 switch is set to display port 85 codes.
What does it means? Is there a switch to flip somewhere? Because I haven't seen anything in the guides I've read.
Any idea?
Regards,
Alex