Hi,
Hardware type: ProLiant DL380 G7
We are using ILO command to reset the boot order of a DL 380 G7 machine to boot it from Network.It gets reset.But when it goes through boot.. Boot order again get reset to default just before the Boot device selection screen and force to boot machine from the Hard Disk.
Exact message on the screen is as below.
"The Standard Boot Order (IPL) has been reset to the system default.Please run the ROM Based Setup Utility to change the default boot order."
(Attached screenshot for reference.)
How we can stop this resetting to default action.Is there any option in BIOS.
Firmware version:1.55
Smart Array controller version:5.70 typep540i