Hello!
I run DL360 Gen 10 server with Smart Array E208i-a, which I use as boot device,
I use legacy boot mode.
Now I need to add external jbod to it, so I bought P408E-P.
I can install it, it can create array on external jbod, problem is in boot- in boot menu I can see only 408E, as you can see on picture, so server tries to boot from it, not from 208, and, obviously, fail.
I can see both devices in boot menu if I remove/install 408E , i.e. if it is new hardware for system and there is no jbod connected to it.
As you can see both controllers are installed.
I just installed latest SPP, but no luck.
Could you tell me can I boot system from 208 while both 208 and 408 are installed?
Thank you!