Let me preface this by saying this is the first server I have ever owned and while I am very adept at building/fixing/installing desktop PCs I seem to be a bit out of my element with this one... I bought it to use as a learning experience and maybe to set up for a home backup/media server... Apparently I'm the class dunce at the moment....
I purchased a used ML350 rack mount (no idea what revision it is) in an auction recently from the state of Iowa. All the drives were removed as one would expect (except they also kept the drive trays) so I am starting from scratch. I plugged in a hard drive using the internal SATA 0 port and turned it on. It boots the BIOS normally (as far as I have seen from other people's videos online) and verything goes according to what I would expect but I have been unable to get any operating system to install on it.
I have tried using CentOS 6 minimal, Ubuntu mini, etc., since those will fit onto a CD-R which seems to be the only kind of burnable media that the CD drive can read. When I have put a DVD-R in it it can't read it. Also tried using an old USB key that had Linux Mint live on it. In all cases if I plug the drive into the internal SATA 0 or SATA 1 connector the installer doesn't seem to recognize it. If I plug the hard drive in via a USB adaptor however it works up to a point. it would let me go through the installation process and prepare the hard drive but it always seems to fail when it comes time to start installing the OS. The machine was connected to the Internet and in the case of the mini installs it was able to download all of the software it needed.
I downloaded the SmartStart ISO yesterday and tried using it to start the machine up last night. It seems to load properly but then simply stops after about three or four minutes. If I hit ESC to see what is going on it seems to be stalling after identifying the Ethernet card. The only error message I see is Fatal error: no screens found.
Any advice for what I should do to get this thing usable would be appreciated.
