For long time my co-workers added vlan into C7000 Enclousure by graphic interface.
We have cluster but didn't work because virtual connect accept only 162 vlan per interface.
The real problem was when I access Virtual Connect Manager via SSH to configure Vlans.
Blades that limit Vlans was full (162) we receive "failed to add vlan" by console.
But for some reason all over blades those were on limit downlinks felt down of blades.
Looking for interfaces of ESXi was half duplex, and Virtual Connect doesn't work in this mode so that reason the host felt down.
My question is:
First, it is possible the command line to add Vlan and enable smartlink cause half duplex mode in hypervisor?
Second, in command line if don't add speed=auto which speed will be default?
Thanks guys!
We have cluster but didn't work because virtual connect accept only 162 vlan per interface.
The real problem was when I access Virtual Connect Manager via SSH to configure Vlans.
Blades that limit Vlans was full (162) we receive "failed to add vlan" by console.
But for some reason all over blades those were on limit downlinks felt down of blades.
Looking for interfaces of ESXi was half duplex, and Virtual Connect doesn't work in this mode so that reason the host felt down.
My question is:
First, it is possible the command line to add Vlan and enable smartlink cause half duplex mode in hypervisor?
Second, in command line if don't add speed=auto which speed will be default?
Thanks guys!