Hi All,
I have a ProLiant MicroServer Gen8 712317-371.
It's showing the following error currently "Controller firmware revision 2.10.00 NAND read failure: Media is in a WRITE-PROTECTED state" but prior to starting the troubleshooting steps below was showing embedded media manager errors.
I've tried:
- https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-c04996097
- https://support.hpe.com/hpsc/doc/public/display?docId=emr_na-a00048622en_us
And after 7 hours of troubleshooting, I've concluded the NAND is dead. So I can no longer use
- the internal SD card slot it would seem (Device can no longer see it or boot from it)
- Intelligent Provisioning
I can live without the SD card if only I could set up the device to see the SSD I've installed in the ODD bay via the SATA port. The AHCI controller can see it on startup but I can't install anything on it as it's not confgured. Is there a way to achive the following (which is normally done in IP?) via the CLI or a bootable linux USB drive?
https://www.admfactory.com/hp-microserver-gen8-boot-from-ssd-install-on-odd-bay/