Dear all,
My existing environment are;
HP DL180 G6
Smart Array B110i SATA RAID Embedded
1 x 250GB SATA - Configure as RAID 0 - Array A - logical disk1
i want add 1 x 250GB hdd, create new Array B & create new logical disk2,
at power on state server, i plug the new 1 x 250GB.. my new hdd doesn't detect, either by HP ACU/by Windows 2008 svr
1. do i have to power off my server first for having my new hdd detected?
2. did i miss something out or what for having not detected hdd??
after little search, i found about "HP Smart Array B110i SATA Raid Controller Hot Plug Advance Pack"
3. does this license is mandatory for make my new hdd detect & able to configure?
4. is it possible to detect & configure new hdd without buy advance pack license?
many tks in advanced,
regards,
markum fuadi