Hello Everyone!
My apologizes, as I’m still very new to networks and servers and such. I have two servers whose iLO I'm trying to get running, somewhat unsuccessfully. Here is all the information I’ve gathered so far.
Server 1 is plugged into port 33 of a cisco switch with an Ethernet cable that runs to the iLO port on the back of the server. Server 1 is working correctly. Server 2 is plugged into port 17 of a cisco switch with an Ethernet cable that runs to the iLO port on the back of the server. Server 2 is NOT working correctly.
The first thing I did was switch the ports the servers were plugged into (Server 1 got unplugged from port 33 and plugged into port 17 and Server 2 got unplugged from port 17 and plugged into port 33). I can reach server 1’s iLO from my internet browser whether it is plugged into port 17 or port 33 and I cannot reach server 2’s iLO from my internet browser no matter what port it’s plugged into. So I don’t think it’s a port issue.
The next thing I tried was switching the Ethernet cable of server 1 and server 2. Once again, Server 1 iLO is reachable no matter what cable is used and Server 2’s is not. So I don’t believe it is a cable issue.
All the lights on all the different ports are all green.
Server 1 had previously been configured so all I had to do was change the static IPv4 address and default gateway and we were good to go. Server 2 hadn't been configured so I set up the static IPv4 address and default gateway, turn off the IPv6 settings, made sure the iLO dedicated port box was checked.
I’m unsure where to look next on my server. Is there possibly a setting I haven't set up yet?
Thanks,
Jared Keyes