Hi all.
So i got this DL360 G7, and after a year of the mind numming drone from the server, I decided to convert it to a tower server and slap in some watercooling.
All went surprisingly well, until i had to extend the SAS backplane power cables, where i accidentaly reversed the wires. (I have fixed the cable corectly)
So now the Health LED flashes Red and nothing on the SID, Starting the system powers it up for a second and goes to standby again, and does this no matter the config, except when no cpu's are present., the fans also spin up for a hot second.
I have exhausted the manuals and flow-charts and the only info that has given me, is that theres a System Board Fault.
So i was wondering if theres any Debug tools or a pinout for the SAS Power cable? i suspect i killed a voltage regulator or something, on the SAS Power Cable im getting 2xGND 1x12v 2x3.3v and a 2.8v??? is the 2.8v correct or should it have ben 5v maybe?
INFO
DL360 G7 2x X5650 maxed out with 192GB RAM (Motherboard 602512-001) 2x 460W PSU's (505908-001 Controller)
also, this is a secondhand server i got from a school and being 18 i don't have the money to spend on a new motherboard, so im willing to fix the board myself, and i do have good experience in THT and SMT Soldering.
Hope you can help me
Best regards - Gustav K. Andersen