Hi All,
I'm having difficulty trying to console in,via cisco 2901, to a remote HP proliant G6 server through its serial port.
Connection is like this :
Cisco 2901/EHWIC#1/Port 10 -> patchpanel -> (RJ45->Serial) HP Prolient 380 G6
I understand from the output below that cisco 2901 is not clear to send.
cisco2901#
Line 0/1/10,
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 9600/9600, no parity, 2 stopbits, 8 databits
Status: Ready
Capabilities: EXEC Suppressed, Output non-idle
Modem state: Ready
Modem hardware state: noCTS noDSR DTR noRTS
My question is how can I confirm the serial port have the right settings and its operational.
Server is running Red Hat linux.
Many Thanks
