Hi there,
I'm unable to create a RAID configuration with my Smart Array P800 on a Proliant ml110 g6 .
Used disks are WD4001FYYG (x4)
They are detected just fine.
When I try to create a RAID config I get the following error:
- A Fatal error has occurred
- Command 51h
- SCSI Status: 0000h
- Command Status: 0004h
I've also tried it with one disk (RAID 0), still I got the same message mentioned as above.
I've ruled out an defective controller, because I can create RAID configs just fine with 2 HP 36GB 2.5" disks .
Are they unsupported because they don't have HP branding on them?
Thanks in advance!
P.S. This thread has been moved from General to ProLiant Servers (ML,DL,SL). - Hp Forum Moderator