DL380p Gen8 Hyper-V 2012 R2
Hi there, I'm currently testing Hyper-V 2012 R2 on DL380p Gen8 server. I'm a newbie in this area. So, I just want to ask if there is anything I need to know in this setup from HP hardware and software...
View ArticleDL380e Gen8 with 8-bay LFF drive cage with backplane - Where can I purchase...
I am looking at purchasing the DL380e Gen8 With and 8-bay LFF drive cage with backplane, but I will need to use some existing stock of hard discs(Fairly cheap WD 7200rpm 2TBs). I am struggling to find...
View ArticleClik here to view.
Possible defective Smart Array P420 ?
Hello, I purchased a P420 1GB FBWC controller and installed in a ML310e server. With this controller attempting to install any OS (i've tried Windows, ESXi, and Debian Linux) all fail during the...
View ArticleSmart Array P410i : Smartctl makes system freeze
I have several ProLinat Servers that have onboard Smart Array P410i controller, and there os are Fedora 19.I found that smartctl command can cause system freeze.Detail situation is as follows. smartctl...
View ArticleHard disk and memory sticks for HP ProLiant ML150 G6
I want to know what type of memory sticks (RAM) are compatible for the server HP ProLiant ML150 G6, also I want to add a HD for the same server, which HD recommend me? Thanks
View ArticleDL385 G2: Second Processor Issues.
I have tried to add a second processor into a DL385 G2 server and when i turn it on, it will turn off instantly. I have swapped the processors around and that does not solve it. I have tested the...
View Articlereply_queues - module parameter on the hpsa linux module
Hi! "modinfo hpsa" has this parameter: parm: reply_queues:Specify desired number of reply queues. 1-16, default is 4, not to exceed number of online CPUs. (int) Has anybody tried to experiment with...
View ArticleUnable to create a RAID config. on Smart Array P800
Hi there, I'm unable to create a RAID configuration with my Smart Array P800 on a Proliant ml110 g6 .Used disks are WD4001FYYG (x4)They are detected just fine.When I try to create a RAID config I get...
View ArticleML350 G6 memory speeds
Looking at upgrading an ML350 G6 server memory from 4GB sticks (1333Mhz - 24GB total) to something quite a bit more either 64 or 96 GB. I have Kingston currently which has been fine, no problems....
View ArticleDL580G5 Backplane question
So I have a DL580G5 at home and I bought a P420 for it as the P400 doesn't do Sata 6gb and I put 2 intel 730 480GB ssd's in it. when the SSD's were on teh P400 the led's would light up but once I put...
View ArticleHP Smart Array P410
Hi, In my new job, I inherited a DL 180 G6 server from the previous network guy, which is configured on a RAID 5 using a Smart Array P410 controller. As the disk space is getting smaller, I wanted to...
View ArticleReplacement for 1PORT,10K SERIAL SCSI 72GB (Spare 3765597-001)
could some one, please advice correct replacement for 1PORT,10K SERIAL SCSI 72GB(Spare 3765597-001)we have bought 6G DP10K, SAS, 146GB (Spare507283-001) is this compatible replacement? jeromeme...
View ArticleILO 4 Error on Remote Support
Hello,I'm setting up ILO4 (advanced license) on two DL380Gen9. Customer bought Proactive support and I want to configure Remote Support inside ILO, but I getthe following error: Protocol error occurred...
View ArticleMixing Non Hot Plug along with Hot Plug drives
Hello everyone, I have client tha has a DL 320 Gen 8 with P/N 470065-759. The server already has 2 Hot Plug drives and now the client purchased 2 more drives. The drives bought by the client are...
View ArticleML150 G6 Beep Codes
I have a ML150 G6 that beeps when it starts up. The serve is powered on and just after the HP/Proliat/Invent screen is displayed I get a single beep followed by a pause, followed by 2 beeps. I have...
View ArticleNo DVD
Hello Ok I'm new to the HP Proliant server line. Just bought a DL 360 Gen 9 however it didn't come with any dvd's for drivers and stuff. I was able to finally get the drivers from the download site...
View ArticleiLO - inaccessible from server
Hi community, I have some odd behaviour happening with my iLO on a HP Proliant ML110 G7 server. My iLO IP address is not pingable from within the server, nor is the web gui accessible or loading...
View ArticleWindows 2008 R2 installation fail - no HDD detected
Hello all, we recently acquired a Proliant DL585 with 2x72GB SAS HDDs.Windows 2008 R2 install fails because it cannot detect any HDD drives; I tried supplying storage drivers from this...
View ArticleProliant ML310e Gen8 V2 Windows server 2008
After a clean install of windows server 2008 Standard i get this error soon as i make THE FIRST admin log in: "Interactive logon process initialization has failed and Failed to connect to a windows...
View ArticleLinux on HP proliant 360 Gen9 does not boot
Hello, I need to install Centos 7.0/6.5 on HP proliant 360 Gen9 with HP Smart Array P440ar/2G in HBA mode (UEFI boot mode). I need HBA mode because this server is part of Apache Kafka cluster. All...
View Article