I buyed a new ML150 G5 (450162-421).
I don't understand wich combination are allowes with the six sata port on the motherboard.
I have this storage devices:
3 hard disks
1 Iomega Rev
1 Dvd Rom
I would configure in this way:
2 hard disk in raid1
1 hard disk for complete system backup
1 Iomega Rev for external backup
1 Dvd Rom for.... Dvd rom ! :-)
How can I set in bios the raid controller ?
In bios, I set controller #1 in raid mode.
Then, I connected the hard disks in sata 1, 2 and 3 connector (why 4 are black and two are blue?).
I configured the raid1 array inserting the first two hard disk but , after rebooting, i check this:
ARRAY 0 - RAID 1 - MIRROR
SATA JBOD - PORT 3 - NON-CONFIGURED
Is it correct ? Why the port3 hard disk is indicated as "non-configured" ?
Maybe is not possible to use first two connector like raid and the other two as single ?
Is there any configuration manual for raid controller embedded in the server ?
Thanks for your help
P.S. this thread has been moved from ProLiant Servers - Netservers to ProLiant Servers (ML,DL,SL). - Hp Forum Moderator
