I have setup a DL580 with NT4 (SP6A) using the onboard RAID controller for internal disks to support NT.
I have installed a 64bit/66MHz fibre adapter and connected this to a 7 port fibre hub. Attached to the hub are two 4100 RAID arrays. I used the Compaq Array utility in NT to configure the disks in the two 4100's and everything was fine, and NT Disk Administrator formatted the new partitions OK. I then installed more disks in the 4100's but now find that when I run the array program it shows no arrays on either of the 4100's. Meanwhile NT is happy that the partitions do still exist and allows you to use them. Whenever you run the array program it says all drives are unallocated and if you then create arrays and save the changes it immediately defaults back to saying drives are unallocated.
I have installed CP000487 and CP000729 for the array program and fibre card but it still does not work.
HELP - Andy
I have installed a 64bit/66MHz fibre adapter and connected this to a 7 port fibre hub. Attached to the hub are two 4100 RAID arrays. I used the Compaq Array utility in NT to configure the disks in the two 4100's and everything was fine, and NT Disk Administrator formatted the new partitions OK. I then installed more disks in the 4100's but now find that when I run the array program it shows no arrays on either of the 4100's. Meanwhile NT is happy that the partitions do still exist and allows you to use them. Whenever you run the array program it says all drives are unallocated and if you then create arrays and save the changes it immediately defaults back to saying drives are unallocated.
I have installed CP000487 and CP000729 for the array program and fibre card but it still does not work.
HELP - Andy