Hi,
One of my clients has an old HP Proliant ML150 G6 1.0 with a B110i raid controller .
All weekend the server was down and this morning the office manager restarted the server and selected F1 to start a rebuild because there was some error about the raid-1 consistency.
Now when I access the Smart Array B110i SATA RAID Controller on System Board via HP System Management, it shows an exclamation mark on Logical Drive 1 - Mirroring (RAID 1) and states the following:
Percent Rebuild Complete: 0% and this percentage is not growing at all. Looks as if it is stuck there.
All the drives are OK with green check marks
My question is: Why does it need a rebuild if the drives show OK? I have not replaced any drives.
Have a look at the attached image.
Thanks and regards
Alfred56
Thanks and