Hi all,
i have a strange issue and hope someone can point me in the right direction the cacheing is permanently disabled but the reports show capacitor status is ok, i do not know why the cache is permanently disabled or how to switch it back on, i have heard some prople say turn off the server and unplug the card from the PCIe slot or remove all disks while turned off and this should renable but i am unsure of doing this or losing data.
The current performance of the pool is very bad and i am having some major performance issues with the pool
(the pool is also almost full which we are addressing with a new fileserver but as the performance on this unit is so bad it is draging out the migration to the new file server)
Diagnostic report
Smart Array P410i in Embedded Slot : Cache Config Status
Cache Disabled Map 0xfffffffe
Position Device Array Accelerator Status
-------- --------------- ----------------- -------------
0 Logical Drive 1 Enabled Informational
1 Logical Drive 2 Disabled Informational
Read Cache Size 228 MB (0x00e4)
Write Cache Size 684 MB (0x02ac)
Disable Flag Enabled (0x00)
Offset To Extended Cache Disabled Map 256 (0x0100)
Offset To Extended Cache Failure Map 264 (0x0108)
Offset To Extended Read Cache Disabled Map 0 (0x0000)
Cache Configuration Flags 0x02
Total Structure Length 280 (0x00000118)
Maximum Logical Devices Supported 64 (0x0040)
Offset To Extended Write Cache Disabled Map 0 (0x0000)
Fixed Structure Length 256 (0x00000100)
Cache Flags 0x00010004
Position Cache Flag Status
-------- ---------------------------------- -------------
2 Permanently Disabled Warning
16 Flash Backed Cache Module Attached Informational
Cache Disable Code Permanent Disable Flashlight Backup Operation Failed (0x001b)
Total Cache Memory Size 912 MB (0x0390)
Battery Count 1 (0x0001)
Battery Status 0x0001
Parity Read Errors 0 (0x0000)
Parity Write Errors 0 (0x0000)
Error Log All Zeroes (160 x [0x00])
Failed Batteries 0 (0x0000)
Board Present 0x01
Cache Failure Map 0x00000000
Max Error Log Entries 12 (0x0c)
NVRAM Load Status 0x00
Memory Size Shift Factor 10 (0x0a)
Non Battery Backed Memory Size 0 MB (0x0000)
Memory State 0x00
Cache Auto Rev 0x28
Total Controller Memory Size 1024 MB (0x0400)
Percent Read Cache 25% (0x19)
Percent Write Cache 75% (0x4b)
Default Percent Read Cache 25% (0x19)
Default Percent Write Cache 75% (0x4b)
Installed Batteries 0x0001
Cache Support Flags 0x0c
Reserved2 0x00
Detailed Battery Status All Zeroes (16 x [0x00])
Detailed Flashlight Hardware Status 0x00 0xee 0x98 0x00 0x01 0x00 0x00 0x00
Extended Cache Disabled Map 0xfe 0xff 0xff 0xff 0xff 0xff 0xff 0xff
Position Device Array Accelerator Status
-------- --------------- ----------------- -------------
0 Logical Drive 1 Enabled Informational
1 Logical Drive 2 Disabled Informational