I have an old Proliant DL380 (I think G1) running Windows Server 2003. I've got four SCSI drives in a RAID 5 config. I think I need to replace one of the drives (ID 3). When I run the HP Array Diagnostic, I get this:
Array Diagnostic Utility Version 7.40.7.0
Array Diagnostic Utility Inspection Report Version 7.40.1.0
Date/Time: Wednesday, January 08, 2014 3:21:33PM
Computer Model: HP Server
SLOT SUMMARY:
Slot Num Slot Type Array Controllers and Host Adapters Detected
-------- --------- --------------------------------------------
SLOT 0 PCI Integrated Smart Array Controller
SLOT 0 Integrated Smart Array Controller ERROR REPORT:
SCSI Port 2 Drive ID 0 is not stamped for monitoring
SCSI Port 2 Drive ID 3 has exceeded the following threshold(s)
Pred failure errors
SOLUTION: Please replace this drive when conditions permit.
SCSI Port 2, Drive ID 3 ... S.M.A.R.T. predictive failure errors have been
detected in the factory Monitor and Performance data. SOLUTION: Please
replace this drive when conditions permit.
SCSI Port 2, Drive ID 3 ... S.M.A.R.T. predictive failure errors have been
detected in the since power Monitor and Performance data. SOLUTION: Please
replace this drive when conditions permit.
SUBSYSTEM INFORMATION:
Chassis Serial Num: D136FSB1L251
This Controller
Array Serial Number: Not Available
Cache Serial Number: Not Available
Other Controller
Array Serial Number: Not Available
Cache Serial Number: Not Available
I have Array Configuration Utility Ver 7.40.8.0
I tried shutting down the server and replacing drive 3 with another one (same size), but when I powered up the server I got an error saying there was no O/S, so I put the old drive back in and the server started up okay. So how do I replace this drive and get the server to rebuild it?
Attached is the entire Array Diagnostic Report
P.S. This thread has been moevd from Servers > General to ProLiant Servers (ML,DL,SL). - Hp Forum Moderqator