Greetings & Salutations
I have just purchased a ML350 G6 and it will not POST or Show any form of VGA output. when i plugged in the VGA cable to the servers onboard VGA port nothing displays at all. I managed to get to the ILO2 so can see the basic server info e.g. status, cpu, ram etc but when i try to use the remote console i get a black screen just like on the monitor. i tried 4 differnt vga cable just to eliminate that issue and install a PCI GC to no avail. i reset the system maintainace switch which seem to stop it runing like a figther jet constantly and i used jumer 6 only think this might help as per other fourms suggestion but to no avail.
SYSTEM STATUS:
micro controller firmware: 2.9
System ROM: D22 5/5/2011 (backup rom the same)
CPU FINE
SYSTEM HEALTH: OK (from ILO2 summaru screen)
RAM FINE
ILO 2 FINE - can connect and use basic info but nothing as no licence
ILO 2 Firmware: standard and firmware: 16/7/2012, Version 2.12
POST - NO
VGA - NO
system lights at the fron of server: show POWER, SYSTEM HEALTH and NETWORK all Green indiacting fine
NO Beeps, NO RED LIGHTS Nothing
Any sugestions would be most helpful.