Hello , I found the server which I maintain blinks the diagnose LED Light in the front of panel. Then I check SSA CLI it shows the following status, what possible root cause it could be? Can someone provide following steps I can do?
Thanls a lot.
=> ctrl slot=0 show detail
Smart Array P440ar in Slot 0 (Embedded)
Bus Interface: PCI
Slot: 0
Serial Number: PDNLH0BRH9HIUA
Cache Serial Number: PDNLH0BRH9HIUA
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Hardware Revision: B
Firmware Version: 3.00-0
Rebuild Priority: High
Expand Priority: Medium
Surface Scan Delay: 3 secs
Surface Scan Mode: Idle
Parallel Surface Scan Supported: Yes
Current Parallel Surface Scan Count: 1
Max Parallel Surface Scan Count: 16
Queue Depth: Automatic
Monitor and Performance Delay: 60 min
Elevator Sort: Enabled
Degraded Performance Optimization: Disabled
Inconsistency Repair Policy: Disabled
Wait for Cache Room: Disabled
Surface Analysis Inconsistency Notification: Disabled
Post Prompt Timeout: 15 secs
Cache Board Present: True
Cache Status: Permanently Disabled
Cache Status Details: Cable Error
Cache Disable Reason: Temporary disable condition: The cache has been disable
d because the controller detected a cable error to the centralized backup power
source.
Drive Write Cache: Disabled
Total Cache Size: 2.0
Total Cache Memory Available: 1.8
No-Battery Write Cache: Disabled
SSD Caching RAID5 WriteBack Enabled: True
SSD Caching Version: 2
Cache Backup Power Source: Batteries
Battery/Capacitor Count: 1
Battery/Capacitor Status: OK
SATA NCQ Supported: True
Spare Activation Mode: Activate on physical drive failure (default)
Controller Temperature (C): 62
Cache Module Temperature (C): 42
Number of Ports: 2 Internal only
Encryption: Not Set
Express Local Encryption: False
Driver Name: HpCISSS3.sys
Driver Version: 63.10.0.64 Pass 4
Driver Supports SSD Smart Path: True
PCI Address (Domain:Bus:Device.Function): 0000:03:00.0
Negotiated PCIe Data Rate: PCIe 3.0 x8 (7880 MB/s)
Controller Mode: RAID
Pending Controller Mode: RAID
Port Max Phy Rate Limiting Supported: False
Latency Scheduler Setting: Disabled
Current Power Mode: MaxPerformance
Survival Mode: Enabled
Host Serial Number: SGH545VTHS
Sanitize Erase Supported: False
Primary Boot Volume: None
Secondary Boot Volume: None