Hello community. I'm a Foxconn employee at the Houston, Texas location and we service HP Servers. I'm working on a DL380p running Windows. During post I get an error message that states there is a FATAL ROM ERROR and my system ROM isn't properly programmed. At Foxconn we can replace any chip in-house including the physical system ROM part it's a U163. I've replaced that U163 ROM part twice, as well as the iLO ROM U164, the iLO chip itself U160, the ME ROM U149, as well as a few others. I've also tried to up and downgrade the system ROM firmware via the iLO log in page under administration>firmware. So far I have ended up sort on this issue and I have another board that does the same. I've asked ALL fellow associates on the matter and it's the first time they've seen this message as well. Prior to the error message I had an NMI red screen error. That prompted me to replace the system ROM U163 part and now I have the FATAL ROM ERROR message. Any/all info good or bad is greatly appreciated. I'll do my best to answer any questions one may have. Thank you for your time.
↧