Looking for Windows 10-64 bit drivers of HPE Proliant ML150 G6 Server
How can I get all the relevant drivers for HPE Proliant ML150 G6 Server for Win 10 - 64 bit. I specifially look for display and volume drivers.
View ArticleML350P Fan noise is too high under low load.
Hy all, I have an ML350P server that, at the moment, contains only an SSD with Ubuntu Server that is connected to the Intel Sata 1 interface. However, fans are always at 34/35% of speed and the noise...
View ArticleiLO5 no access via web and no ping
Dears,Not able to access ILO5 2.10 via Web Viewer (it was working normally), No Ping to it.I am able to acess it via HP Lights-Out Online Configuration Utility and using manual IP and Shared Network...
View ArticleHP Smart Array B320i RAID Cannot Find Drives
Issue: The newly refurbished DL360e Gen8 cannot see any hard drives, have reset all back to factory settings in BIOS, have ran the HP Smart Array B320i nRAID Controller with no success. Have went...
View ArticleDL380p Gen8 iLO 4 WebGUI doesn't load. Putty/SSH works without issue.
Hi, everyone. The WebGUI of my iLO 4 will not load. I have tried the entire process outlined in this...
View ArticleiLo runs very slowly
I have problems with iLo4 running very slow on DL380e G8. On "iLO Event Log" tab I see critical warning: "Embedded Flash/SD-CARD: Embedded media manager failed initialization".So far I've tried...
View ArticleHigh Fan Noise DL380 Gen10
Intermittently the Fans noise goes high without reason (all fans stay around 50% speed [checked in iLO5]), and the problem cannot be solved until cold restart or disconnection of power and starting...
View ArticleP420i Controller Issue
I have a ProLiant ML50p Gen8 that I purchased refurbished and so far it has been a great server for my lab. However, when I first configured it, I configured RAID 1 with the first 2 drives and now I...
View ArticleDL20 install OS on M.2 NVME
HiI have a new DL20 GEN10 Server and installed an internal M.2 NVME Drive. The drive is shown in BIOS and in SmartStorage Administrator.How can I install an operatin system on this NVME? It does not...
View ArticleRAID REPAIR STROVIRTUAL 4000
Hello,I found a post on this forum about RAID Repair. The prodedure was posted and it's necessary to admin connect in order to put node into repair mode....
View ArticleDL20 Gen10 - M.2 NVME high FAN speed
HiI have installed a NVME in the DL20 Gen10 Server for the Operating system. However, when the NVME is installed, Speed of Fan 1 & 2 is never below 71% (which is quite noisy) despite the...
View ArticleUpdate firmware on dl360 gen9 from esxi host software.
I have a remote server with slow internet access. I need to update the P440AR Smart Array. Booting the ISO for SPP from the ILO times out and never boots. I tried to use the install method from the...
View Article270 Error ilo communication issue
Hello somlebody help meHave hpe proliant DL360 G9.Impossible to update îlo, impossible to boot provisioning média recovery.The screen fix itself at hpe load image after boot.Error code: 270 îlo...
View ArticleML310e Gen8 v2 not able to hot swap power supplies
I have a ML310e Gen8 v2 server with the redundant backplane and 2 x 460w power supplies installed (part no 643931-001). I have noticed that redundancy upon unplugging the cord or loss of AC supply...
View ArticleDrivers for proliant ml110 g6
could not find these drivers for HP Proliant ML110 G6 i have installed windows 10 64 bit...
View ArticleProliant ML110 Gen10 Controller and Video Issues
I have a Proliant ML 110 Gen10 server that I am using as a Terminal Server with Windows 2012 R2. It has a single Intel Xeon Bronze 3104 1.7 Ghz CPU, a 1TB 3 drive RAID 5 array made from 3 500GB SSD...
View ArticleEnd of Sale and End of Support dates
Hello,I am planning for the server renewal and I need end of sale (end of life) and end of support dates for the following server products. I tried to find information but no success after lots of...
View ArticleDL20 Gen10-Intelligent Provisioning not showing NVME drive as an install target
HiI have a similar Problem/Quention for a DL20 Gen10 I am currently working on. I could not get the Intelligent Provisioning to show me the NVME drive as an install target. What are the required steps...
View ArticleSystem Management Homepage and SSL Certificates
Good day!I'm looking into remediation of a vulnerability for self-signed certificates on our Systems Management Homepage.I've found how to do the remediation manually, individually for a server, but I...
View Article