Hey all, we have a DL380P 25-bay SFF that we have been trying to get going. It was operational when it was shut down (to the best of our knowledge), but since bringing it to our office it will not post or give any display when powered on and the system health LED is flashing red. I will break down what has been done to try and resolve this issue.
1. Connected to iLo, it shows Bios/Hardware critical, does not show any server specific info such as firmware revisions etc it all says not available.
2. Reflashed the firmware for both the bios and the iLo - No Change
3. Took the server to minimal config with just 1 CPU, 1 stick of RAM - No Change
4. Tested the CPUs and RAM in another server and it booted without issue
5. Disconnected the SAS controller - No Change
6. Replaced the SAS controller with one out of a working server - No Change (although the SID on it does show the CPU as amber, if we have both CPUs installed it shows both as amber, if we drop it to 1 CPU it shows that 1 as amber, even with CPU from a working server, and having tested this CPU in another server and verifying functionality and that the CPU does not show amber on that server)
7. Replaced the power supplies and connector module to the motherboard with ones out of a working server - No Change
8. Replaced all of the fans with ones out of a working server - No Change
9. Replaced the PCI Riser with one out of a working server - No Change
10. Removed the raid cache card - No Change
11. Replaced the raid cache card with one out of a working server - No Change
12. Replaced the CPU with an identical one out of a working server - No Change
13. Reset iLo by removing the battery and power - No Change
14. Removed the NIC card - No Change
15. Replaced the NIC card with one out of a working server - No Change
16. Replaced the motherboard - No Change
17. Set the Dip switches 1,5,6 - No Change
18. Set the Dip switch 6 - No Change
19. Replaced the memory with memory from a working server - No Change
20 - Ensured we have the memory seated in the correct slots per the 1CPU and 2CPU config diagram on the case - No Change
At the point we replaced the motherboard, we took the old board and set it up on our bench outside of the case to be sure it wasn't a grounding issue - No Change
We now have 2 motherboards doing the same thing, one with the original hardware that was with it, and the 2nd with all the hardware on it having come from a running server.
When the server is powered off all lights are green. When we power the server on all lights stay green, fans spin up, right after that the system health LED goes to flashing red, no display, no post. If we leave it on the fans will occasionally still spin up/down as if trying to regulate temperature but they don't "stay spun up"...
We are at an absolute loss here.